1 Reply
0 Likes
Philip.Joung STAFF commented
pass count and fail count in summarize output
2 days ago in Products Community
2 Replies
0 Likes
George_Popovici answered
can you use iTest to connect to an STC and configure devices to transmit and receive eCPRI & RoE packets
3 days ago in Products Community
1 Reply
0 Likes
Todd Law answered
Error in Spirent TestCenter Automation Programmer's Reference
4 days ago in Products Community
3 Replies
0 Likes
Philip.Joung STAFF edited
Is it possible to generate frame with 3 byte SFD instead of normal 1 byte SFD from Spirent TestCenter?
4 days ago in Products Community
0 Replies
0 Likes
Philip.Joung STAFF commented
Where are the TestCenter release notes?
4 days ago in Products Community
1 Reply
0 Likes
1 Reply
1 Likes
kashif
Steve answered
Can you running script with LS using python and not TCL?
5 days ago in Products Community
1 Reply
0 Likes
cthomas101 answered
Ethernet over GRE (Transparent Ethernet Bridging 0x6558) support in Spirent
6 days ago in Products Community
1 Reply
0 Likes
1 Reply
0 Likes
Rodney_Stanton commented
Is there documentation/training on setting up a Raw Stream Block to setup ARP header and see Wireshark capture? I want to setup and send 1000 arps per second and see it on wireshark.
Jun 6, '19 in Products Community
1 Reply
0 Likes
Boris Henning answered
Which VM operating system platforms can I install Spirent on?
Jun 5, '19 in Products Community
1 Reply
0 Likes
Boris Henning answered
Manual based scheduling is greyed out in Spirent TestCenter. How can I enable it?
Jun 5, '19 in Products Community
2 Replies
0 Likes
mnakamura answered
How to generate IP traffic whose rate changes with time by C1 chasis?
Jun 4, '19 in Products Community
1 Reply
0 Likes
Products Community
Products Community
34 People are following this space.
