My prompt shows up in the response view.
I created a test case and when I go to creating analysis rules I noticed that prompt was included in the response body. Switch Ports Model SW Version SW Image ------ ----- ----- ---------- ---------- * 1 28 WS-C3750G-24PS 12.2(20050726:174023) C3750-I9-M Configuration register is 0xF Cisco3750-1# The test case however runs fine.
If the test case runs fine, then it means that the prompt is getting properly captured by iTest. So if you go to the Structure view, the prompt query properly shows "Cisco3750-1#". This tells me that you are getting two prompts and iTest is fetching the second one. Most likely, this is due to the fact that your device is configured for r as your termination character, but iTest is sending rn for termination character which is default in iTest. The termination property needs to be updated at the session profile level.
1 Person is following this question.
