question

User1234 avatar image
User1234 asked User1234 edited

I am updating my simulator by UDP and getting warnings. then the simulator ignores further UDP updates.

After running my simulation for about 2000 seconds I consistently get a

Warning V1_M1 Max Posn Error =0.104m Max Vel Error = 0.021 m/s

Then my simulator will proceed on the last vector it was on and it will not use the UDP updates anymore. I can stop the simulation and rewind it then play again and it will take the continued update until it happens again. Where can I find more information on the warning message?

udpwarning
10 |950

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

1 Answer

·
User1234 avatar image
User1234 answered User1234 edited

I don't know if this is related, but If I get my simulation to hover in one spot so there is no position change. Therefor my UDP packets stay in sync with the position. After just over an hour

I get

1:11:34 Fatal: V1_M1: Remote_Model Motion_out of sequence last 1271310319 current 4705612 Where the current number just counts up

With that the output of the simulator stops. I can restart the simulation and it will go back to using the UDP data.

10 |950

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

Write an Answer

Hint: Notify or tag a user in this post by typing @username.

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.