Hi all,
I want to use Spirent Testcenter to test openflow performance,but there are little help to do it.
With help of helpbrowser, i enable OSE model with switching bar,but i hit "apply" button, it throw the error,
"7/6/2019 09:12:38 .6 Error Other ViewControlPlaneMplsBindingCommand 1 failed with error: There were 1 validation error(s); aborting apply. Image on Virtual Port: Port //1/1 does not contain OSE package. Please refer to OSE Virtual Quick Start Guide for installation instructions.."
I am very appericate it if you tell me how to deal with it,thank you!
Answer by mnakamura · Jul 08, 2019 at 08:13 PM
Are you using Spirent TestCenter hardware or is this virtual?
Visit the Spirent Customer Service Center support webpage. https://support.spirent.com/SpirentCSC/
Look in the Downloads section.
For Spirent TestCenter hardware download the OSE firmware but please note in the Description section that OSE is only supported on specific hardware.
For OSE virtual, there is a separate download to create an OSE VM.
The Quick Start Guide can be found under Related Resources. See snap shot.
Of course be sure you also have the license for it. Go to your GUI under Tools->License Management and check if you have something called OpenFlow Switch Emulation.
If you have everything set and still have errors, please open a case with support@spirent.com.
Hi, sorry to reply so later.
Yeah,you did help me a lot, and i got help from Spirent Support also.
Thank you again!
Copyright 2008- Spirent Communications, all rights reserved. Terms and Conditions.