Hi All,
One of our customer is trying to change the test package from STC to L4-7 in MX-100G-F2 in 4.20 . Module got struck in rebooting stage attached screenshot .
After that it was not getting detected by STC anymore.
I checked in the release notes, and couldn't find any information regarding the support of this module for avalanche .
Can anyone confirm whether this module is supported by Avalanche and if not then what is the reason for this kind of behavior . Please advise regarding the solution for this issue .
Regards,
Arnab
Answer by Michelle Rhines · Dec 30, 2014 at 08:58 PM
MX-100G-F2 is not currently supported by Avalanche Commander (For a complete list of supported hardware for any given release please refer to the Avalanche release notes).
Regarding the ability to change the test package to L4-7 and getting stuck in a reboot state I recommend opening a service request with support to have a bug filed to address.
Does Spirent TestCenter or Avalanche have test cases for the HTB QoS mechanism? 0 Answers
Are there ways of testing WAP and SFTP using Avalanche or Spirent TestCenter ALP? 1 Answer
How to configure DUT using pexpect, paramiko and Python 3 within TestCenter 1 Answer
Controller 3 Firmware Failure 3 Answers
Copyright 2008- Spirent Communications, all rights reserved. Terms and Conditions.