question

BorisHenning avatar image
BorisHenning asked mnakamura answered

bucket size setup for histograms in traffic analyzer

Hallo Team,

now I know how to enable histograms on C1. Next step would be to set the bucket size at the traffic analyzer. The histogram tab at the traffic analyzer is missing on C1 ports. Any idea?

Kind Regards

Boris

Spirent TestCenter (STC)C1reports
1 comment
10 |950

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

hasanin avatar image hasanin commented ·

I have the same issue. Any answers?!

0 Likes 0 ·
mnakamura avatar image
mnakamura answered

Update: NIC-65 and NIC-68 support histograms but only in 1G mode.

10 |950

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

mnakamura avatar image
mnakamura answered

Do you mean removing High Speed Results Analysis to try and get Histograms results? Removing HSRA gives another problem where the rates are limited which means depending upon your Histogram it may be affected. It doesn't seem to be a good idea to test with HSRA unchecked. Well with that said, I did find a case mentioning the Histogram tab is not seen even with HSRA unchecked. Unfortunately the final decision on this was that we do not officially support Histograms even with HSRA unchecked.

10 |950

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

Write an Answer

Hint: Notify or tag a user in this post by typing @username.

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.