Hi ,
The output of the summarize command is shown as
Completion Result: Fail
Test Case: testcases-batch
Location: project://my_project/test_suites/testcases-batch.fftc
Owner:
Start Time: Wed Jul 06 11:28:36 IST 2011
Duration: 00:10:59
Total Issues: 8
Report Id: 5572
Execution issues for this test case:
Is it possible to get the below paramaeters in the summarize command along with the ones shown above?
1) total report items
2) Pass/Ok
3) Fail/Error
These parameters are seen in the summary of the testreport of any testcase.
Thanks
Chaitra
Answer by George_Popovici · Jun 14, 2019 at 09:31 AM
Hi @chaitra te,
I assume that in testcases-batch.fftc you have a series of 'run' commands for iTest test cases. If my assumption is correct, could you try adding the summarize command after all the 'run's inside testcases-batch.fftc file and see what the output is? It should have what you are looking for.
Thanks,
George
@Brenaj , FYI on a possible solution to your question from yesterday.
I actually found the info/warning/error/all counts by issuing an "eval puts [info issueCount warning]".
Answer by Amresh Gunjan · Jul 06, 2011 at 12:26 PM
Hi Chaitra,
We can not modify the output of the summarize command step. To view those details you will have to see the test report.
Hey, Chaitra, I'm filing a feature request for this. I can't guarantee this will go in any particular release, but this at least shouldn't get lost.
Thanks Kevin.
This feature would be very helpfull , with out this it is difficult to look through the entire report in case we are running batch from a testcase , to find the number of passed and failed count.
Regards
Chaitra
tooltips for blue boxes 1 Answer
Adding a call to something not in favorites 1 Answer
command line help would be nice 2 Answers
How does some one call a procedure from a global rule? 1 Answer
My test is running, but where am I? 2 Answers
Copyright 2008- Spirent Communications, all rights reserved. Terms and Conditions.