question

mk avatar image
mk asked ericnute edited

Spirent RFC 2544 issues

Hello,

 

Have been using Fanfare 4.1 version.

 

Following are the two issues that I have observed when I run the saved sequencer for RFC 2544 tests (Latency test) from an STC XML configuration file (USING STC GUI in Fanfare):

 

1.> Using the Fanfare STC GUI Session profile, it shows the sequencer steps executing for every iteration, but however it does not Display the value of the counters or update the counters.

 

2.> If the Sequencer contains to generate a Report, the Fanfare STC GUI is also not able to generate the Report in either STC-CLI or STC-GUI session profile.

 

Kindly assist on overcoming these two issues.

 

Best Regards,

MK

iTestSpirent TestCenter (STC)traffic generationrfc 2544
10 |950
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

1 Answer

·
mk avatar image
mk answered mk posted

Kindly note that, when the attached XML file is loaded & executed in the Spirent Test centre everything works GREAT!!

However via the Fanfare STC-CLI or GUI it fails (above mentioned two issues)


Best Regards,

MK


RFC2544_latency_US.xml (247.9 KiB)
2 comments
10 |950
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

akazantsev avatar image akazantsev commented ·

Hi MK,

Did you tried to subsribe for interesting results from statistic page?

 

Thanks,

-Alex

0 Likes 0 ·
akazantsev avatar image akazantsev commented ·

Can you try to export configuration to TCL script and execute it via TCL shell?

0 Likes 0 ·

Write an Answer

Hint: Notify or tag a user in this post by typing @username.

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.