Do Parameters work with the Web Gui?
Do parameters work in the web gui?
I can get this to work fine when using telnet, but I cannot get it to work when I am using it in the web gui.
For instance, I am trying the following command in one of my steps where I use a parameter for the version of code that I am trying to download:
The value of the parameter "SW_Test" is set to "07".
When I run the test case, it does not do a substitution of the "SW_Test" with the "07" value. Any ideas?
Chris
The value of the parameter "SW_Test" is set to "07".
When I run the test case, it does not do a substitution of the "SW_Test" with the "07" value. Any ideas?
Chris
Just to be sure, is the "For the command field, perform command, variable, and backslash substitutions" checked for this step?
Since your command body has backslashes, field substitution is disabled on that step by default.
You can go to the step properties of that step and click on the little grey button next to the text field to enable substitution on that step.
Keep in mind that now that it is enabled, you would need to escape the slashes already in your response
Here is another post about enabling field substitution in the Target field. It is a good example:
http://forums.fanfaresoftware.com/fnfr/board/message?board.id=iTestGeneral&thread.id=3488
candrews,
This is unrelated, but I see a lot of "mouseover" actions in your test case (the screenshot).
If many cases (as it seems in your case), they are useless for the sake of the test. In the Web session properties you can turn on/off capture of 'mouseover' actions. It will produce much cleaner tests from capture.
